An LG Dryer That Would Not Heat in Burr Ridge
A Burr Ridge homeowner called A+ Appliance Repair and Maintenance about an LG dryer that was not heating up. On a gas dryer, no heat while the drum still turns points to the ignition system, and our technician traced it to the igniter, the component that lights the gas at the burner. When it fails, the drum tumbles and the cycle runs, but no heat is produced and clothes come out damp. We replaced the igniter and confirmed the dryer heated and dried correctly. A no-heat gas dryer is one of the most common dryer repairs there is.
An LG Dryer That Ran but Left Clothes Wet in Burr Ridge
A homeowner in Burr Ridge called A+ Appliance Repair and Maintenance about an LG dryer that was not heating up. The drum turned and the cycle ran, but the clothes came out damp because no heat was being produced. On a gas dryer, that specific combination, running but not heating, points at the ignition system, and this one came down to the igniter.
How a gas dryer makes heat
A gas dryer produces heat by burning gas at a burner, and lighting that burner is the job of the igniter. When the dryer calls for heat, the igniter heats up and lights the gas flowing to the burner, producing the hot air that dries your clothes. The igniter works every heat cycle, and like any part that repeatedly heats up, it wears out over time.
When the igniter fails, the gas is never lit, so no heat is produced, even though everything else about the dryer works. The motor still turns the drum, the cycle still counts down, and air still moves, but it moves cold. That is why a dryer with a failed igniter tumbles a full cycle and leaves the clothes as damp as they went in. It is one of the most common causes of a gas dryer that runs without heating.
Diagnosing it properly
A no-heat gas dryer can come from a few sources, the igniter, the gas valve coils, the safety and thermal components, or the gas supply, so our technician diagnosed the unit rather than assuming. Tracing the fault to the igniter meant the repair could target the actual failed part. That accurate diagnosis is what keeps the repair efficient and correct rather than a series of guesses.
The repair
We replaced the igniter. With the new igniter in place, it lit the gas as it should, the burner produced heat, and the dryer dried properly again. Our technician confirmed the dryer heated and completed a drying cycle correctly, verifying it under real operation. On a no-heat complaint, confirming the dryer actually produces heat and dries a load is the measure of a completed repair.
Keeping a gas dryer heating well
Airflow matters for both heat and safety. Clean the lint filter every load and have the vent and ductwork cleaned periodically, because restricted airflow makes a dryer run hot and work harder, which stresses the heating and safety components and is a leading cause of dryer fires. If a gas dryer starts taking longer to dry or you notice it running without much heat, have it looked at, since a dryer that tumbles without heating will not fix itself, and the cause is usually in the ignition and gas components. Catching a heating issue early keeps it a straightforward repair.
About A+ Appliance Repair and Maintenance
We service LG, Samsung, Whirlpool, Maytag, GE, and every other major dryer brand throughout Burr Ridge, Hinsdale, Willowbrook, and the surrounding communities. Our technicians are certified to work on gas appliances safely and carry common parts, so a no-heat dryer repair can usually be diagnosed and completed in a single visit.
We quote the price upfront before any work begins, we waive the service call fee when you move forward with the repair, and every completed repair is backed by our full repair warranty. If your gas dryer is tumbling but not heating, we can find out why and get it drying properly again.
