How the Artisan Fire oven is laid out
Kalamazoo makes one pizza oven, the Artisan Fire. It sits on a counter and burns gas. Think of it as two ovens working on one pie.
The lower burner heats the baking stone from below. The upper burner sends flame across the roof of the oven. Each has its own knob. The cook sets them apart to match the dough. Kalamazoo says the burners can take the oven to 800 degrees, and a thin pie is done in about two minutes.
That split design is why our first question is simple. Is the top wrong, the bottom wrong, or both? See our Kalamazoo appliance repair page for the other gear we fix.
Reading the pizza
- Charred top, white base. The lower burner is weak or out.
- Crisp base, raw cheese. The upper burner is weak or out.
- Both slow. Gas pressure is low, or the oven was not given time to heat.
- One edge burns. The stone is off its supports or the flame is lopsided from blocked ports.
Give the oven a fair preheat before you judge it. Kalamazoo quotes about 20 minutes. If it needs 40 on a mild day, something is wrong.
A burner that will not light
Each burner has an igniter beside it. Flour is the enemy here. It drifts off the peel, burns to a crust and covers the igniter tip. Rain and salt air add rust. We clean the tip, check the gap and test the spark.
No spark on either burner points upstream. The battery or power feed for the ignition may be dead, or the module has failed. No gas sound at all points to the valve or the supply.
Flame that drops out
If the Artisan Fire burner lights, then dies as you let go of the knob, the flame sensor is not doing its part. This probe sits in the fire and holds the gas valve open. Soot makes it read cold. Age wears it out.
We clean the probe and test how much signal it makes. If it is weak, we fit a new one. If the probe is good, the safety valve it feeds is next on the list.
Stones, weather and owner checks
Baking stones crack from shock. Cold dough on a very hot stone is fine. A wet rag or a splash of water is not. A cracked stone that sits flat can stay. Loose pieces should be replaced so they do not block the lower flame.
The oven is open at the front, so wind matters. A strong cross wind can pull heat off the stone and tip the flame. If results change from day to day, note the wind. It may not be a fault at all.
Water is the other weather problem. A cover keeps rain out of the burners. If the oven sat open through a storm, run it on low for a half hour to dry it before you cook.
Look at the gas first. A propane tank can feel heavy and still be near empty in cold weather. Make sure both knobs turn fully. Brush the stone when it is cool. Look into each burner with a light and check for webs. Spiders like gas tubes.
Our visit and the price
Artisan Fire bookings begin at 6 AM, and Artisan Fire bookings stop at 9 PM. You can call or book on the site, and same-day visits are usual. The tech tests pressure, spark and both flames.
The Artisan Fire diagnostic at a home is $79. Approve the oven repair and you skip that $79. The same goes for the $119 stacked or double unit call. We give one fixed price up front. Labor and parts are part of that price. A+ is an independent shop one family has run. Every Artisan Fire tech carries a license and insurance and passed a background check at hiring. We back the repair with a 30-day repair warranty.
Repair is nearly always right
This oven is a block of welded stainless steel with a few gas parts in it. Igniters, probes, valves, burners and stones can all be changed. Nothing about it wears out as a whole.
Own the grill too? See Kalamazoo grill repair. For the oven in your kitchen, use our general oven repair guide. We repair Artisan Fire ovens for owners around Los Angeles, and our crews in Texas, Illinois, Virginia and the District do the same. When we finish, we fire both burners and time the stone to 700 degrees with a heat gun.