The hoods ILVE makes
ILVE builds wall mount hoods to pair with each of its range styles. There are Majestic, Nostalgie, Professional Plus and Panoramagic hoods. They are sized to the range below, with 30, 36 and 40 inch models among them. ILVE rates the blower at 600 CFM. The fan has three speeds plus an intensive boost. A light bar with LEDs runs along the front edge. A chimney cover hides the duct, and ILVE sells extensions for tall ceilings.
This page is about the hood itself. That means the blower, the lights, the filters and the switches. For the range under it, see our ILVE range repair page.
The fan runs but smoke hangs in the room
A hood that sounds fine yet pulls poorly rarely has a bad motor. Nine times in ten, the air path is blocked. Start with the metal grease filters. Hold one up to a light. If you cannot see through it, it needs a wash. Most can go in the dishwasher.
Next comes the duct. A damper flap sits where the duct leaves the hood, and another at the outside wall. Grease can glue either one shut. A duct that was crushed or run too long also chokes the air. Hold a sheet of paper towel up to the filters on high speed. The hood should grip it firmly. If it falls, the air is not moving.
Blower, light and switch faults
- Fan dead on all speeds. The hood motor, its capacitor or a board fuse has failed.
- Fan hums but will not spin. The capacitor is weak or the wheel is jammed with grease.
- Rattle or roar. The blower wheel is loose on its shaft or out of balance.
- One speed missing. The switch or control board has lost a contact.
- Boost will not engage. A control fault, since boost runs through its own circuit.
- Lights out. The LED driver has failed, more often than the LED strip itself.
- Lights flicker. A loose plug between the light bar and the board.
- Drips of grease. Filters are full or the hood is tilted the wrong way.
Why the blower motor fails
Heat and grease kill hood motors. The motor sits right in the stream of hot, oily air. Over years, grease works into the bearings and they start to drag. The motor runs hot, hums and then stops. Clean filters slow this down a great deal. So does running the fan for a few minutes after you finish cooking. That clears the damp, greasy air before it settles inside.
A big ILVE range puts out a lot of heat. With several brass burners on high, the hood has real work to do. Use the intensive speed for searing and wok work, then drop back.
The repair visit and its price
Your tech pulls the filters, checks the damper and runs each speed. We measure the motor's draw and test the capacitor. Then we check the lights and the control. A hood diagnostic at a home costs $79. We drop that $79 once the hood repair is approved. The same goes for the $119 stacked or double unit call. The hood price is set first and takes in labor and parts. Hood techs here hold a license and insurance. Each one has cleared a background check. Common motors and capacitors ride on the truck, but ILVE trim parts may ship from Italy.
When a hood is worth fixing
An ILVE hood is painted or plated to match the range, often in a custom color. That alone makes repair the smart path. Motors, capacitors, switches and drivers are all fair jobs. A new ILVE hood only makes sense if the body is badly dented or the part is gone for good. We are an independent company, so you get that advice with no push from a maker.
Where we service ILVE hoods
ILVE hood work takes us all over Houston, and the Texas appliance repair page names the nearby towns. Hood calls also come from D.C., from Chicago, from Los Angeles and from Northern Virginia. Our ILVE Majestic service page covers the brand. General hood advice lives on our vent hood repair page. We also handle ILVE cooktop repair. When you book, tell us how high the hood hangs. Tall chimney installs need a longer ladder, and we like to bring it the first time.