How a DishDrawer is built
A DishDrawer slides out of the cabinet like a deep kitchen drawer. The wash tub, spray arm, filter and motor all ride inside that drawer. A lid drops onto the tub to seal it once the drawer shuts. The double model stacks two of these, and each one runs alone. Fisher and Paykel also sells drop door dishwashers with a normal hinged front. Both types are on the brand's US site today.
That moving tub changes how the machine wears. The fill hose, drain hose and wiring all bend each time you open it. They are carried in a flexible link at the back. After years of daily use, that link is a usual place to look. See the full list of what we service on our Fisher and Paykel appliance repair page.
A drawer that beeps and quits
When a DishDrawer finds a fault, it stops and beeps. Newer models show an F code or an A code. Fisher and Paykel lists F1 as a flood alert or too much foam. Its advice is to run a cycle with no soap. If that clears it, cut your detergent back to a teaspoon. Water on the floor is a different story. Turn off the power and the water and call.
Other stops come from parts that wear out:
- The wash motor or the drain pump under the tub.
- The part that heats the wash water.
- The valve that lets water into the drawer.
- Wires in the rear link that have cracked from bending.
Water left in the bottom
Standing water is the call we get most on this brand. Start with the filter. It lifts out of the tub floor and rinses clean at the sink. If water still sits there, the drain side is blocked or the pump is jammed. We often pull out a shard of glass or an olive pit. The drain hose can also kink where it loops under the sink.
Drips down the drawer front
Water on the drawer face usually traces to the lid seal. Grease builds on it, and then it cannot seal flat. A dish or pan handle that sticks up past the rim can hold the lid open too. Too much soap makes foam that pushes past the seal. We clean and check the seal before we price a new one.
What you can do first
Rinse the filter. Check that nothing blocks the drawer from closing all the way. Spin the spray arm by hand to be sure it turns. Look under the sink for a kinked hose. After that, cut power at the breaker for sixty seconds and run one more cycle. Please leave the drawer on its rails. Pulling it off can tear the hoses in the link.
Price and timing of the visit
Finding the fault on a DishDrawer at a house costs $79. A stacked or double unit is $119. Approve the work and that charge is dropped. Before any part goes in, we name one set figure for labor and parts. Many DishDrawer parts ride on the truck, so one trip is common. A+ is an independent company and has been family owned. Each DishDrawer tech has a license, an insurance policy and a passed background check. Online booking is open. DishDrawer jobs are scheduled from 6 in the morning until 9 at night, all week.
Keeping a DishDrawer or replacing it
A DishDrawer fits a cabinet opening that a standard dishwasher may not. Swapping it can mean new cabinet work. So a pump, seal or lid motor is nearly always worth doing. We think twice when the control board is no longer made. We also think twice when both drawers of an old double fail close together.
We repair these in Los Angeles and across our California service area. DishDrawer jobs also come from Houston, D.C., greater Chicago and Northern Virginia. Other makes are on our general dishwasher repair page. Have a drawer fridge from the same brand acting up? Our Fisher and Paykel refrigerator repair page covers it. One habit helps every DishDrawer last. Load tall items toward the back so nothing sits under the lid.